Saxton Bronze

Saxton Bronze


	Donor Recognition Trees


	General The stones for our traditional trees are sculpted cast bronze and have an .020" leaded brass plate attached to the surface for engraving. The contemporary stones are cut from 1/4" thick yellow brass (which matches the contemporary trunk) and also come with an .020" leaded brass plate for engraving. Saxton does provide engraving for these products.

	Small Bronze Size: 5-1/2" x 3-1/2" Material: Cast bronze stone with 4-3/4" x 2-3/4" x .020" blank brass plate for engraving
	Large Bronze Size: 7-1/2" x 5" Material: Cast bronze stone with 5-3/4" x 3-7/8" x .020" blank brass plate for engraving
	Small Brass Size: 7" x 4-3/4" Material: 1/4" thick cut out yellow brass with 4-3/4" x 2-3/4" x .020" blank brass plate for engraving
	Large Brass Size: 11-1/2" x 8" Material: 1/4" thick cut out yellow brass with 5-3/4" x 3-7/8" x .020" blank brass plate for engraving
	Cast Donor Stone Size: 12" x 8", "Rock-Edge" border design Material: Cast bronze with integral, cast copy (up to four lines)

Helpful Hints

All leaves and the plates for the stones are made from leaded yellow brass with a clear, protective lacquered finish. Once they are engraved, an oxidizing solution may be used to turn the copy black.